200x120x75mm IP65 ABS Plastic Mount Enclosure BoxModel Dimensions: 200mm (L) x 120mm (W) x 75mm (H)Ingress Protection: IP65-rated (dust-tight and water-resistant)Material: Acrylonitrile Butadiene Styrene (ABS) PlasticMounting Type: Wall-mountablePhysical DimensionsExternal Dimensions:Length: 200mmWidth: 120mmHeight: 75mmInternal Dimensions:Length: 192mmWidth: 112mmHeight: 69mm (accounting for lid thickness and gasket seal)Wall Thickness:Average thickness: 3mm for enhanced durability.Material DetailsMaterial Composition: High-quality ABS plastic.Thermal Resistance:Operating temperature: -20°C to 85°C.Flammability rating: UL94-HB.UV Resistance: Suitable for limited outdoor use; prolonged UV exposure may cause discoloration.Impact Resistance:Tested for IK08 mechanical impact.Ingress Protection (IP65)Dust Resistance: Fully protected against dust entry.Water Resistance: Resists low-pressure water jets from all directions (tested to IEC 60529 standards).Mechanical FeaturesLid Design:Hinged or detachable flat lid.Includes silicone gasket for a tight seal.Screw fasteners: Stainless steel, corrosion-resistant.Mounting Options:Wall-mounting: Pre-molded screw holes for quick installation.Panel-mounting: Optional DIN rail compatibility.Cable Management:Optional knockouts or gland entry points (depending on model variation).Smooth, drillable surfaces for custom cable entries.Surface Finish: Matte finish for a professional appearance and scratch resistance.Electrical & Environmental SpecificationsElectromagnetic Shielding: Not shielded (can accommodate optional EMI coatings).Dielectric Strength: Suitable for low-voltage applications.Chemical Resistance: Moderate resistance to oils, grease, and weak acids/alkalis.ApplicationsIndustries:Industrial control systems.Electrical junction boxes.Network and communication hubs.Use Cases:Housing for circuit boards or controllers.Outdoor/indoor switchgear protection.Sensor or telemetry device enclosures. SKU: LKELEC00241 Categories: Electronics accessories, Enclosure, Robots and DIY Kits
